This lesson helps you understand the true capabilities and limitations of equalization in room correction systems, focusing on professional-grade adjustments.
EQ Fundamentals:
Equalization modifies the amplitude response of a system. In REW, you work with parametric equalizers using biquad sections.
Key Parameters:
Frequency: Center frequency of the filter
Gain: Amount of boost/cut in dB
Q Factor: Bandwidth of the filter (lower Q = wider band)
Type: Bell (bandwidth symmetric around center), High Shelf, Low Shelf
Biquad Characteristics:
Each biquad section can implement one of these filter types:
Peaking EQ: Symmetric boost/cut around center frequency
High Shelf: Affects frequencies above cutoff (6 dB/octave slope)
Band Pass: Only affects frequencies within the bandwidth
Notch: Cuts frequencies within the bandwidth
Phase Implications:
Each EQ adjustment also affects phase response. Minimum-phase adjustments have predictable phase effects, while non-minimum-phase corrections can create complex interactions.
Professional EQ Techniques:
Target Matching: Load a target response and adjust EQ to minimize the difference.
Peak Taming: Focus on reducing broad peaks (typically ≥ 1/3 octave wide) rather than narrow dips.
Subwoofer Alignment: Use phase adjustments and low-frequency EQ to align multiple subs.
Room Mode Control: Target specific modal frequencies with narrow Q adjustments.
Step 1: Measure Individual Subs
Capture impulse responses for each subwoofer position.
Step 2: Phase Alignment
In the IR graph, align the direct sound arrivals
Use the phase tab to adjust relative timing
Look for constructive interference patterns in the summed response
Step 3: Frequency Alignment
Use narrow Q adjustments to match frequency response
Focus on modal frequencies first (room dimensions × speed of sound)
Avoid excessive boosting which wastes headroom
Step 4: Verify Results
Check both frequency response and impulse response for improved summation.
EQ Limitations:
Understanding what EQ cannot do is crucial for professional work:
1. Cannot Fix Dips
Sharp dips from destructive interference cannot be fully corrected by EQ. Attempting to boost these wastes headroom and may damage speakers.
2. Phase Limitations
Non-minimum phase behavior (like room modes) cannot be fully corrected by amplitude-only EQ.
3. Position Dependency
EQ adjustments are only valid at the exact measurement position. High frequencies vary significantly with position.
1. Phase Distortion:
Amplitude equalization inherently affects phase response, potentially creating new issues.
2. Pre-Ring Artifacts:
Time-domain artifacts appearing before the main impulse can occur with excessive EQ, particularly high-frequency boosts.
3. Headroom Reduction:
Boosting frequencies reduces available headroom, increasing the risk of clipping during dynamic peaks.
Quiz: EQ Concepts
What is the primary limitation of equalization in room correction?
a) It can only affect high frequencies
b) It cannot fully correct sharp dips
c) It requires special hardware
d) It only works with subwoofers
What is the purpose of a high shelf filter in EQ?
a) To cut low frequencies
b) To boost high frequencies above a cutoff
c) To remove midrange frequencies
d) To flatten the entire response
Why is phase alignment important when combining multiple subwoofers?